Hide Table of Contents

Copy, Move, Rotate, and Scale in One Operation

Use the QuickModify command to copy, move, rotate, and scale entities in one command.

You can modify the basepoint as needed.

To copy, move, rotate, and scale entities in one operation:

  1. Click Modify > Quick Modify (or type QuickModify).
  2. Specify a base point for subsequent modifications.
  3. In the graphics area, specify entities to modify.
  4. Press Enter.
  5. Specify an option:
    • Base. Specify a new base point for subsequent modifications.
    • Copy. Specify one or more destination points to displace copies of the specified entities, then press Enter.

      Use the Base sub-option to specify a new base point in between copying. Specify Exit to finish copying.

    • Move. Specify the destination point.
    • Rotate. Specify the rotation angle.
    • Scale. Specify the scale factor.
    • Undo. Withdraws the last operation.
  6. Repeat the previous step to perform more modifications.
  7. Specify Exit to end the loop of repeated operations.

Access

Command: QuickModify

Menu: Modify > Quick Modify



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Copy, Move, Rotate, and Scale in One Operation
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.