Hide Table of Contents

Defining Diameter Dimensional Constraints

Use the DcDiameter command to constrain the diameter of a Circle, Arc, or curved PolyLine segment.

To define diameter Dimensional Constraints:

  1. Click Constraints > Dimensional Constraints > Diameter (or type DcDiameter).
  2. Specify a curved entity (Circle, Arc, or curved PolyLine segment).
  3. Specify the dimension position.
  4. If necessary, edit the dimension parameter value.
  5. Press Enter or click in the graphics area.

  If you specify an entity for which a diameter or radius constraint is already defined, you receive a message that the constraint already exists.

Access

Command: DcDiameter

Menu: Constraints > Dimensional Constraints > Diameter



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Defining Diameter Dimensional Constraints
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.