Hide Table of Contents

Working with EntityGroups

You can combine drawing entities into EntityGroups.

Grouping entities lets you manipulate all entities within the group in a single operation (moving, rotating, mirroring, or scaling, for example). However, you can still edit individual entities in a EntityGroup (intersecting or stretching, for example) by changing the EntityGroup display mode.

You can add or remove entities from an EntityGroup any time.

Entities can be members of more than one EntityGroup. EntityGroups can be contained in other EntityGroups.

The differences between Blocks and EntityGroups are:

  • A Block has its own insertion point. An EntityGroup has none.
  • A Block can occur multiple times in the drawing. If a Block is redefined, all of its occurrences update. EntityGroups do not behave the same way.
  • You can copy groups. An EntityGroup that originates from another EntityGroup that has been copied is a separate union of entities. Each Block has a unique name, but not its references.

You can create unnamed or named EntityGroups.

These topics discuss the commands to create and manage EntityGroups:



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Working with EntityGroups
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.