Hide Table of Contents

Working with Points

Points are often used as temporary drawing aids, similar to InfiniteLines and Rays.

You can use the Single Point or Multiple Points commands to place points in a drawing.

MarkDivisions and MarkLengths are commands you can use when creating points. These commands place points, or symbols, along other drawing entities. You can use them to set out distances along a Line or more complex entities, which is useful in construction processes.

You should set a point format before placing points in a drawing because they can be difficult to see after you place them.

This section discusses:



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Working with Points
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.