Hide Table of Contents

Shortcut Menus

Right-clicking displays a shortcut menu (context menu).

Right-clicking displays a shortcut menu (context menu).

Right-click by holding down the control key on the keyboard and click the mouse to display shortcut menus (also called contextual menus).

If a command is active, the shortcut menu displays:

  • Enter: Confirms default options of the current command or ends entity selection
  • Cancel: Cancel command execution
  • ESnap Overrides: Lets you select entity snap options and coordinate input methods
  • Pan and Zoom
  • Options that are available at the current prompt

If no command is active, the context menu displays commonly used commands:

  • Repeat previous command
  • Cut, Copy, Copy with Reference Point, Paste, and Paste as Block
  • Undo and Redo
  • Pan and Zoom
  • Options (general settings)
  • Drafting Options

Related Topics

Menu Bar



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Shortcut Menus
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.