Hide Table of Contents

Setting the LineStyle Scale Factor

Use the LineScale command to set a global scale factor for LineStyles. It affects all drawing entities to which you assigned a LineStyle pattern.

The dash lengths specified in the LineStyle definition files (in drawing units) are multiplied by the factor specified with the LineScale command.

  You can determine individual LineStyle scale factors by entity in the Properties Palette.

Access

Command: LineScale



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Setting the LineStyle Scale Factor
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.