Hide Table of Contents

Saving Component Edits

The SaveComponent command saves changes made during a Component editing session and ends the session. In-place editing of Block definitions or References is invoked by the EditComponent command.

To save an in-place edited Block definition or Reference:

  • Click Modify > Component > Save and Close (or type SaveComponent at the command prompt).

    The Block definition or Reference changes are saved and Component editing mode ends.

    All instances of the Block or Reference in the drawing reflect the changes.

  Use CloseComponent to save or discard the modifications of in-place editing of Components.

Access

Command: SaveComponent

Menu: Modify > Component > Save and Close

Related Topics

In-Place Editing of Blocks and References

Adding or Removing Entities During Component Editing

Modifying the Base Point of a Block Definition

Terminating Component Editing



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Saving Component Edits
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.23