Hide Table of Contents

Creating Parallel Dimensions

The ParallelDimension command creates aligned linear Dimensions.

Parallel dimensioning is a type of linear dimensioning that measures and labels the absolute distance between two points, regardless of the relative position of the axes. This lets you dimension Lines, edges, or spaces that are not located on the principal axes of the coordinate system, that is, not parallel to X-, Y- or Z-axes of the coordinate system.

To create parallel Dimensions:

  1. Click Dimension > Aligned (or type ParallelDimension).
  2. Specify the first and second extension line origins.

    - or -

    Press Enter, then specify an entity to dimension. You can specify Lines, PolyLines, Circles, and Arcs. With Lines, PolyLines, and Arcs, the start and end points of the entity are measured. With Circles, the diameter is measured. The pick point on the Circle is used as start point of the first extension line along the perimeter of the Circle.

  3. In the graphics area, specify the position of the dimension line or use the Angle, Note, or Text options. See Editing and Formatting Dimension Text.

    The measurement is placed as Dimension text based on the definitions of the current DimensionStyle.

Access

Command: ParallelDimension

Menu: Dimension > Aligned



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Parallel Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.