Hide Table of Contents

Modifying Dimensions

Use the EditDimension command to change the position, angle, and value of Dimension text. You can also change the orientation of the extension lines of Dimensions.

To modify Dimensions:

  1. Type EditDimension at the command prompt.
  2. Specify an option:
    • Angle. Rotates the Dimension text of existing Dimensions. Specify the rotation angle. To revert rotated Dimension text to its default orientation, enter an angle of 0°. The option works the same as the Angle option of the EditDimensionText command except that you can specify multiple Dimensions with the EditDimension command.
    • Home. Undoes the move or rotation of Dimension text and returns it to its original position (default).
    • Move. Relocates the dimension line and the text of existing Dimensions in one operation.
    • New. Modifies the Dimension text value. Enter a text value or <> to represent the generated measurement. You can revert the Dimension to its generated measurement or add a prefix or suffix to the generated measurement. For example N-<> generates the value N-24 if the Dimension measurement generates 24.
    • Oblique. Modifies the orientation of existing linear Dimensions. Specify a new angle for the extension lines.
  3. Select the Dimension to update.
  4. Press Enter.

    The specified Dimensions are updated.

Access

Command: EditDimension



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Modifying Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.