Hide Table of Contents

Creating Jogged Dimensions

The JoggedDimension command creates jogged radius Dimensions for Circles and Arcs.

Jogged dimension lines are typically used when a sheet is too small to display the true center point of radial Dimensions. The command lets you specify another origin point for the dimension line. This point is called the center position override.

The command measures the radius of the specified Circle or Arc and displays the Dimension text with a preceding radius symbol.

To create jogged Dimensions:

  1. Click Dimension > Jogged (or type JoggedDimension).
  2. In the graphics area:
    1. Select an Arc or Circle.
    2. Specify a point for the center position override.
    3. Specify the position of the dimension line or specify an option:

      Angle, Note, or Text: See Editing and Formatting Dimension Text.

    4. Specify a jog position.

Access

Command: JoggedDimension

Menu: Dimension > Jogged



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Jogged Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.