Hide Table of Contents

Editing Dimension Text

Use the EditDimensionText command to move or rotate Dimension text for a single Dimension.

Use the EditDimension command to edit multiple Dimensions.

To edit Dimension text:

  1. Type EditDimensionText at the command prompt..
  2. Specify a Dimension.
  3. Specify a new position for the dimension text and dimension line.

    - or -

    Select an alignment option:

    • Angle. Rotates the Dimension text about its center by the angle you specify.
    • Center. Moves the text to a center-justified position within the Dimension.
    • Home. Undoes the move of Dimension text and returns it to its original position.
    • Left. Moves the text to a left-justified position within the Dimension.
    • Right. Moves the text to a right-justified position within the Dimension.

    The Dimension text moves as specified.

  Use the EditDimension command to change the position, angle, and value of Dimension text. You can also change the orientation of the extension lines of Dimensions.

Access

Command: EditDimensionText

Menu: Dimension > Align Text



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Editing Dimension Text
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.