Hide Table of Contents

Creating Area Boundaries

You can create an area boundary from existing entities that form a 2D enclosed area.

Use the AreaBoundary command for:

  • Area calculations
  • Hatches
  • Extracting outlines based on temporary constructions

The entities can be a combination of Lines, Arcs, Circles, PolyLines, Ellipses, elliptical Arcs, and Splines. The entities can be in any arrangement as long as the boundary makes an enclosed area without overlap.

To create AreaBoundaries:

  1. Click Draw > Bound Area (or type AreaBoundary).
  2. In the dialog box, set options:
    • Find nested boundaries. Controls whether the command detects internal closed areas that are completely within the boundary area.
    • Under Performance, in Analyze entities, select the set of drawing entities that are analyzed when defining a boundary from a specified point:
      • As Displayed. Establishes the boundary set from everything currently visible on the drawing screen.
      • Entities specified. Displays the number of specified entities after you click Specify entities  to select drawing entities on screen to form the boundary set.
    • Under Type, select whether to define the boundary by PolyLine or Region.
  3. Click OK.
  4. Click any point inside the closed area to designate as a boundary entity. To create other boundary entities, click additional internal points.
  5. Press Enter.

Access

Command: AreaBoundary

Menu: Draw > Bound Area



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Area Boundaries
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.