Hide Table of Contents

Creating a Mask

You can create a Mask, a figure that overlays existing geometry with the current background color. The existing geometry is not erased.

The Mask command allows you to draw a polygonal shape or select an existing polygon to mask underlying entities. After you place the polygon over a section of the drawing, you can add entities on top of the polygon.

Annotate a masked area by placing opaque Text near it, or by highlighting areas of a drawing that need to be re-detailed, for example.

You can turn off Mask frames to seamlessly blend with existing drawing entities. This is helpful before you print a drawing.

  To control the visibility of different scenarios with Masks, use Layers.

To create a Mask out of points:

  1. Click Draw > Mask (or type Mask).
  2. In the graphics area, specify points in a sequence that define the contour of the area to mask.
  3. Press Enter.

To create a Mask from a PolyLine:

  1. Click Draw > Mask (or type Mask).
  2. Specify the PolyLine option.
  3. In the graphics area, select a PolyLine. The PolyLine must be closed and consist of Line segments with zero width.
  4. Specify the Yes option.

To show or hide Mask frames:

  1. Click Draw > Mask (or type Mask).
  2. Specify the Frames option.
  3. Specify the Yes option to show Mask frames. Specify the No option to hide them.

Access

Command: Mask

Menu: Draw > Mask



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Mask
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.