Hide Table of Contents

Splitting Entities

Use the Split command to erase part of an entity between two points. Use Split as a construction tool or to create a gap between two parts of an entity to place Text or a symbol. Use the command with Lines, Circles, Arcs, PolyLines, Ellipses, Splines, InfiniteLines, and Rays, but not with RichLines.

To erase part of an entity:

  1. Click Modify > Split (or type Split).
  2. In the graphics area, specify an entity.

    The point you click is the location where you want to begin the break.

  3. Specify the second break point to determine the section to delete.

    You can instead select the First point option to specify the first point explicitly, in which case you are prompted next for the second point.

    The portion between the two points is erased.

To cut off one end of an entity:

  1. Click Modify > Split (or type Split).
  2. Click an entity at the point where you want the new end point to be.
  3. Click the other point past the entity's current end point.

    The entity is cut off at the point you clicked on the entity.

To split an entity into two entities:

  1. Click Modify > Split (or type Split).
  2. Click an entity at the point where you want to split the entity.
  3. Enter @ to repeat the initial point.

    The entity is split into two pieces without erasing any part of it. This method is useful if you want to split an entity where it intersects another entity.

    Note: The Modify toolbar contains an icon Split that lets you split an entity at one point into two entities by specifying the single split point.

Access

Command: Split

Menu: Modify > Split



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Splitting Entities
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.