Hide Table of Contents

Scaling Entities

Use the Scale command to enlarge or reduce entities while keeping proportions the same.

To scale entities:

  1. Click Modify > Scale (or type Scale).
  2. In the graphics area, select entities to scale.
  3. Press Enter.
  4. Specify the base point.

    The base point, if part of the specified entities, holds its original position during scaling, while all other points move by the same relative values in the direction of the X-, Y-, and optional Z-axis. For the base point, you can instead select a point not on an existing entity. In this case, the distance from the base point to all other points making up the entity change by the same scale factor.

  5. Enter the scale factor or specify the Reference option to enter a reference length and a new length. Optionally, specify the Points option to represent the reference length as two points.

    A scaling factor larger than 1 enlarges the entities by this factor. A scaling factor between 0 and 1 reduces the entities by this factor. For instance, the factor 3 enlarges the selected entities three times, while the factor 0.25 reduces the entities to a quarter of their original size.

    Use Reference to specify an exact change in the lengths of entities. For example, to enlarge an entity with a side length of 3.45 drawing units up to 3.54, you have to calculate the scaling factor. With Reference, however, you specify the reference length (3.45) and the new length (3.54).

Access

Command: Scale

Menu: Modify > Scale

Related Topics

Stretching Entities



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Scaling Entities
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.