Hide Table of Contents

Controlling the Visibility of Fills

You can control the visibility of fills for wide PolyLines, Solids, Traces, Hatches, and Gradients.

To control the visibility of fills:

  1. Type DisplayFills at the command prompt.
  2. Specify an option:
    • On: Turns on fills.
    • Off: Turns off fills. Only the contours of entities are displayed.

Note: You control LineWeight display with the Options command. In the Options dialog box, click Drafting Styles > Active Drafting Styles > Line Font > LineWeight, then set the Display weight in graphics area option.

Access

Command: DisplayFills

Related Topics

Turning Boxed Text Mode On and Off

Setting the Display Quality of Circles and Curves

Setting User Preferences and System Options



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Controlling the Visibility of Fills
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26