Hide Table of Contents

3D Viewing Using Horizontal RollView

Use the RollViewHorizontal command to swivel the view of your model horizontally about an imaginary vertical axis.

To view the model in 3D using horizontal RollView:

  1. Do one of the following:
    • Click View > 3D Orbit > Horizontal Orbit on the menu.
    • Click View > Render > Horizontal Orbit on the ribbon.
    • Type RollViewHorizontal.
  2. In the graphics area, drag the pointer.

    A green pivot point  appears in the center of the model. If you selected entities before you entered RollView mode, the pivot point appears at the center of the selected entities.

    Note: The arcball feature is not available in this RollView mode.

  3. Press Esc or Enter to exit RollView mode.

Access

Command: RollViewHorizontal

Menu: View > 3D Orbit > Horizontal Orbit

Ribbon: View > Render > Horizontal Orbit

Related Topics

3D Viewing Using Vertical RollView

3D Viewing Using RollView

3D Viewing and Presentation

Parent Topic

3D Viewing Using RollView Commands



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   3D Viewing Using Horizontal RollView
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.48