| |
Depth |
Set a new value to change the hole depth.
|
| |
Diameter |
Set a new value to change the hole diameter.
|
| |
Modify Draft |
Select to remove drafts from the hole. Make sure Apply Draft is cleared.
|
| |
Apply Draft |
Select to change the hole's draft angle. Make sure Modify Draft is selected. To change the hole's draft angle, set a new Angle, and select either Only Inward or Only Outward to change the draft slope.
|
| |
Reverse Offset
|
Select Any, On,
or Off. (For Offset From
Surface as End Condition
only.) |
| |
Translate Surface
|
Select Any, On,
or Off. (For Offset From
Surface as End Condition
only.) |