Hide Table of Contents
This example shows how to fillet and stretch sketch entities.
  1. Start DraftSight and open a new drawing.
  2. Using the following form:
    1. Select Create and fillet one pair of sketch entities.
    2. Click Run Macro.

             - or -

  1. Select Create and stretch three sketch entities.
  2. Click Run Macro.

  1. Inspect the drawing.

NOTES:

  • Errors are printed to Output.
  • To recreate this example:
  1. Right-click the topic and select to view the source.
  2. Save the file as an HTML file.
  3. Open the HTML file in your web browser.
  4. If using Windows Internet Explorer and running scripts is blocked, click the Information bar near the top of the webpage and select Allow Blocked Content.

 
Create and fillet one pair of sketch entities
 
Create and stretch three sketch entities
 

Output


 




Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Fillet and Stretch Sketch Entities Example (JS)
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:



x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: API Help (English only) 2019 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.