Hide Table of Contents

Zoom Bounds

Zoom Bounds displays the entire drawing even if only a portion of the drawing has entities.

Zoom Bounds zooms to the current bounds of the drawing if no entities extend beyond these bounds. If entities extend beyond the defined bounds, they are included in the calculation of the boundaries in which to zoom.

Using Zoom Bounds in a 3D view is the same as using Zoom Fit.

To use Zoom Bounds:

  • Click View > Zoom > Bounds.

  Zoom Bounds cannot be used transparently because it always rebuilds the drawing.

Access

Command: Zoom, option Bounds

Menu: View > Zoom > Bounds

Related Topics

Zoom Fit

Zoom

Dynamic Zoom



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Zoom Bounds
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59