You can use one of several methods to create Circles.

To construct a Circle from its center point and radius:

- Click
**Draw > Circle > Center, Radius**(or type**Circle**). - In the graphics area, specify the:
- Center point of the Circle.
- Circle radius.

To construct a Circle from its center point and diameter:

- Click
**Draw > Circle > Center, Diameter**. - In the graphics area, specify the:
- Center point of the Circle.
- Circle diameter.

To construct a Circle from three points:

- Click
**Draw > Circle > 3 Points**(or type**Circle**then specify the**3Point**option). - In the graphics area, specify three points that define points on the Circle.

To construct a Circle from two points along the diameter:

- Click
**Draw > Circle > 2 Points**(or type**Circle**then specify the**2Point**option). - In the graphics area, specify two points that define the Circle diameter.

To construct a Circle from two tangent entities and the radius:

- Click
**Draw > Circle > Tangent, Tangent, Radius**(or type**Circle**then specify the**Ttr**option). - In the graphics area:
- Select a point on each of two linear entities that define lines tangent to the Circle.
- Specify two points to define the radius, or type the radius value.

To construct a Circle that is tangent to three lines:

- Click
**Draw > Circle > Tangent, Tangent, Tangent**(or type**Circle**then specify the**TTT**option). - In the graphics area, specify a point on three linear entities that define lines tangent to the Circle.

This option is useful when inscribing the Circle within a regular polygon.

Access

Command: Circle

Menu: Draw > Circle

x

Never show this message again

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

x

Web Help Content Version: 2020 SP01

To disable Web help from within SOLIDWORKS and use local help instead, click **Help > Use SOLIDWORKS Web Help**.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.