Gusset PropertyManager

To open the Gusset PropertyManager:

Click Gusset on the Weldments toolbar, or click Insert > Weldments > Gusset.

Supporting Faces

	Select Faces	Select adjacent planar faces from two intersecting structural members.
	Flip Profile D1 and D2 Parameters	Flip the values between Profile Distance1 and Profile Distance2.

Profile

	Triangular Profile	Click to create a triangular gusset, then set values for Profile Distance1 and Profile Distance2.
	Polygonal Profile	Click to create a polygonal gusset, then set values for Profile Distance1, Profile Distance2, and Profile Distance3. Then select one of the following: d4 Set a value for Profile Distance4. a Set a value for Profile Angle.
	Chamfer	Click to create a chamfer to allow room for a weld bead under the gusset. Set Chamfer Distance5, then select one of the following: d6 Set a value for Chamfer Distance6. a2 Set a value for Chamfer Angle.
	Thickness	Select where to apply gusset thickness: Inner Side Both Sides Outer Side (For all of the above images, Location is set to Profile Locates at Mid Point.)
	Gusset Thickness	Set a value.

Location

Location	Select where to locate the gusset profile: Profile Locates at Start Point Profile Locates at Mid Point Profile Locates at End Point
Under Location, select: Profile Locates at Start Point (Thickness set to Inner Side ) Profile Locates at Mid Point (Thickness set to Inner Side ) Profile Locates at End Point (Thickness set to Outer Side )
Offset	Select if you want to offset the gusset location, then specify an Offset Value. Click Flip Offset Direction to change the offset direction.