Setting Fixed Length to Route Segments

Add more route segments to the Fixed Length PropertyManager by selecting them in the graphics area...After you set a fixed length, you can perform the following tasks: Edit a fixed length by right-clicking the route segment and clicking Edit Length...Remove a fixed length by right-clicking the route segment and clicking Fixed Length

Fixed Length PropertyManager

Fixed Length PropertyManager...Set the fixed length of the route segment. Dimension Display Control the...

Routing Tools Toolbar

. Repair Route Fix bend radius errors...Fixed Length...Show Fixed Length Dimensions Show/Hide fixed length...

Slopes

If one end of the pipe route is fixed, then vertical segments of the route are shortened or lengthened to accommodate the sloped pipe segment...other end of the pipe route is not fixed, then the entire pipe route, including the fittings, are adjusted to move up or down

Access to Pipe, Tube, or Electrical Harness Coverings

... the Covering Library. You can also create custom coverings with fixed diameters. Click Coverings (...

Flanges

A flange is often used at the ends of a routing run to connect the pipe or tube to a fixed component, such as a pump or tank

Adding a Slope

if the fitting has been fixed or has an external mate that prevents the fitting from moving...The start point must be a fixed point that the route segments can use to rotate and create the slope

Mating Fittings in Routing Subassemblies

. If the fitting is fixed or mated, it always drives the sketch, and its status cannot be changed. ...

Slope PropertyManager

The start point must be a fixed point that the pipe segment can use to rotate and create the slope.

Prerequisites for Building Pipe and Tube Routes

... be avoided. Position the fixed components using mates, dimensions, or relations on a layout sketch,...

Glossary

Typically a purchased part, the cable has a fixed length and a fixed part number...A tube or hose with a fixed length and a fitting at each end

Ribbon Cables

... is not supported. Use of fixed-length standard cables is not supported. Drawings of the flattened ...

Reusing an Electrical Route

... of the reused harness and the fixed length parameter is applied. All configurations, if more than ...

Reusing Routes for Tubes and Hoses

... tube route assembly and the fixed length parameter is applied. All configurations, if more than ...

Prerequisites For Electrical Routing

... avoided. Position the fixed components using mates, dimensions, or relations to a layout sketch, ...

Route Properties PropertyManager

Fix diameter...Select to fix the route diameter to the value set in OD...If you want to highlight a fixed diameter route, click Routing > Routing Tools > Highlight Fixed Diameter Route...

Routing Options

Displays error messages where you can click How do I fix this...for detailed suggestions for fixing the error