> Example of Bodies to Keep

SolidWorks Fundamentals

Design Studies in SolidWorks

Detailing and Drawings

Sustainability Products

Example of Bodies to Keep

Cut Extrude

Cut extrude thin feature intersecting three solid bodies.	Preview of cut extrude with bodies to keep in dark shade.	Cut extrude with thin feature applied.

Cut with Surface

Surface feature intersecting seven solid bodies.	Preview of cut with surface with top section of arcs as the bodies to keep	Cut with surface applied.

Cut with Loft

Cut with loft intersecting four solid bodies.	Preview of cut with loft with bodies to keep highlighted.	Cut with loft applied.

Search 'Example of Bodies to Keep' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Example of Bodies to Keep
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.