Hide Table of Contents

Lock Dimensions

Use Smart Dimension to select:

  • Distance between two points at an angle.

  • Angular dimensions

Use the pointer to control positioning.

Pointer is unlocked. Change the measurement and the position of the dimension.

Pointer is locked. Measurement is locked; dimension position is available.

To lock a dimension:

  1. In an open sketch, click Smart Dimension (Dimensions/Relations toolbar) or Tools, Dimensions, Smart.

  2. Click the items to dimension.

  3. Move the pointer until the preview indicates the dimension type you want.

  4. Right-click to lock the dimension type.

  5. Move the pointer around until the dimension is correctly located.

  6. Click to place the dimension.

  7. Set the value in the Modify box and click .

Related Topics

Angular Dimensions Between Three Points

Angular Dimensions Between Two Lines

Dimensioning Arcs

Circular Dimensions

Point-to-Point Dimensions



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Lock Linear Dimensions
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.53