Hide Table of Contents

Edit All Auto Reliefs

You can change the type of auto reliefs automatically added to the bend regions in sheet metal parts.

You cannot edit relief cuts in sheet metal parts created in versions prior to SolidWorks 99.

To change the type of relief cut for all bends:

  1. Right-click the Sheet-Metal feature in the FeatureManager design tree and select Edit Feature.

  2. In the PropertyManager, under Auto Relief, change the type of relief cut.

  3. If you select Rectangular or Obround, specify the Relief Ratio.

  4. Click OK .



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Edit All Auto Reliefs
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.53