> Example of Boundary Surface Alignment

SolidWorks Fundamentals

Design Studies in SolidWorks

Detailing and Drawings

Sustainability Products

Example of Boundary Surface Alignment

The alignment options control alignment of the boundary surface iso parameters, which control the flow of the boundary surface.

Boundary surface feature

The mesh shows the iso parameters for the
boundary surface feature.

Starting surface

Ending surface

Selected curve

Align with next section Aligns the boundary surface iso parameters to the iso parameters of the start and end surfaces, based on distance.

Align with section normal Aligns the boundary surface iso parameters normal to the selected curve.

Align with other geometry Aligns the boundary surface iso parameters with greater influence determined by the end points of the selected curve.

Align with iso parameter Aligns the boundary surface iso parameters to match the flow of the iso parameters of the starting surface at the selected curve.

Search 'Example of Boundary Surface Alignment' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Example of Boundary Surface Alignment
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.