Hide Table of Contents

Smart Fasteners Defaults

You can specify the default Smart Fasteners components to use with different standards and hole types. You can also make the fastener's length change when the hardware stack changes, and make the stack hardware size change when the fastener's size changes. For details, see Toolbox Help: Toolbox - Smart Fasteners.

An administrator can restrict modifications to the Smart Fasteners data. Other users can view, but not modify, the restricted data without the administrative password. For details, see Toolbox Help: Toolbox - Permissions.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Configure Data - Smart Fasteners
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.53