Hide Table of Contents

Broken-out Section PropertyManager

The PropertyManager for a broken-out section controls:

Depth.

  • Depth Reference . Select geometry, such as an edge or an axis, in the same or a related view.

Use 3D drawing view mode to select an obscured edge for the depth.

Depth is set to the center of the circle.

Depth is set to silhouette edge of cylindrical face.

  • Depth .

Preview. When selected, the broken-out section is displayed as you change the depth. If there are other views in the drawing, the break and depth planes appear on the views.

Auto hatching. For assemblies only. If selected, the software adjusts automatically for neighboring components to alternate crosshatch patterns in 90 degree increments. If there are still adjacent section faces with the same pattern, the pattern spacing is adjusted.

Exclude fasteners. For assemblies only. Excludes fasteners from being sectioned. Fasteners include any item inserted from SolidWorks Toolbox (nuts, bolts, washers, and so on) except for structural members. You can also designate any component as a fastener so it will not be sectioned.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Broken-out Section PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.53