Component Library Fields
The component library contains the following fields.
|
Field |
Description |
|
Part Number |
A unique value for each component.
The value in this field must match values in the From
Part or To Part fields
in the from-to list. |
|
SolidWorks Document |
The name of the SolidWorks part
for this component, such as db15e.sldprt
or c:\myparts\plug.sldprt. This
can be a relative pathname (relative to the location of the component
library .xml file) or a full pathname. |
|
Configuration |
The configuration of the SolidWorks part to use for this component. |
|
Description |
A text description of the component. This field is for information only;
the value is not used by the software. |
|
Pins List |
A comma-delimited list of pin names/numbers (for example, 1,2,3,4,5
or In,Out,Gnd). This field is
used only when you create a harness drawing. |
|
Terminals |
A comma-delimited list of terminal part numbers that apply to the connector
(for example, 3289435,34872634,485903).
This field is used only when you create a harness drawing. |
|
Size (Gauge) |
A numeric value or dash-delimited range of values representing the allowable
sizes of terminals or wires that can fit into the connector's pin cavities
(for example, 2.5 or 2.5-4.0
for millimeters, or 20 or 20-24 for gauge.). This field is used
only when you create a harness drawing. |
|
Plug |
The part number of the plug used with the component. |