Hide Table of Contents

Rotating and Aligning Clips

You can rotate clips in a route sub-assembly.

  • To facilitate aligning the clip's axis with an edge or axis in the assembly, the clip must have an axis named Clip Axis.

  • To facilitate rotating the clip to the desired orientation, the clip must have an axis named Axis of Rotation.

To align or rotate a clip:

  1. While editing the route, click Rotate Clip (Routing Tools toolbar) or Routing, Routing Tools, Rotate Clip.

To rotate clips while editing the route sub-assembly (but not editing the route), right-click a clip and select Add/Edit Mates (Rotate Clip).

  1. Set options in the Component Rotate/Align PropertyManager.

  2. Click .

You can also rotate clips as you place them in an assembly by holding down Shift and pressing the left and right arrow keys. Specify the rotation increment in Routing Options by setting Component rotation increment (degrees).

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Rotating and Aligning Clips
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21