Hide Table of Contents

Display States in Configurations

You can create multiple display states for each configuration of an assembly or part..

To control display states in a design table, you must link display states to configurations. Select Link Display States to Configurations at the bottom of the Display States section on the ConfigurationManager tab .

In a design table, the column header for controlling the active display state uses this syntax:

$DISPLAYSTATE

The column header is not case sensitive.

In the table body cells, enter the display state name. If a cell is left blank:

  • For new configurations, the system adds Display State-<n> to the table.

  • For existing configurations, the system adds the name of that configuration's most recently active display state.

Example of a design table that controls the display state of assembly configurations:



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Display States in Configurations
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46