Spring PropertyManager

Springs are simulation elements that move components around an assembly by simulating the effects of various types of springs.

Spring Type

• Linear Spring (Basic Motion and Motion Analysis only). Represents forces acting between two components over a distance and along a particular direction. SolidWorks Motion:

  • Calculates the spring forces based on the distance between the locations of the two components

  • Applies a force to the first part you select

  • Applies an equal and opposite force along the line of sight of the second part you select

• Torsional Spring (Motion Analysis only). Represents torsional forces acting between two components. SolidWorks Motion:

  • Calculates the spring moments, based on the angle between the two parts about the specified axis

  • Applies a moment about the specified axis to the first part you select

  • Applies an equal and opposite reaction moment to the second part you select

Spring Parameters

• Select two features for Spring Endpoints.

• Select the Exponent of Spring Force Expression based on the Functional Expressions for Springs.

• Set the Spring Constant based on the Functional Expressions for Springs.

• Set the Free Length. The initial distance is the distance between the parts as currently displayed in the graphics area. Select Update to model changes to have the free length dynamically update to model changes while the PropertyManager is open.

Damper

Select the Damper section (Motion Analysis only) to allow entry of values.

• Select the Exponent of Damper Force Expression.

• Set the Damping Constant.

Display

You can view the display values  only when the Spring PropertyManager is open, or when you calculate the study.

• Coil Diameter.

• Number of Coils.

• Wire Diameter.

Load-bearing Faces

Click under Load references, and select components in the graphic area for Load-bearing Faces/Edges to transfer them to  SolidWorks Simulation.

Notes

• Springs apply a force to a component. A spring with a higher spring constant moves a component faster than a spring with a lower spring constant. A component with a smaller mass moves faster than a component with a larger mass when acted upon by an equal strength spring.

• The spring does not exert any force when its length is equal to its free length.

• Motion due to motors supersedes motion due to springs. If you have a motor moving a component to the left and a spring pulling a component to the right, the component moves to the left, and the power consumption of the motor increases.