Hide Table of Contents

Re-routing to Ignore Clips

You can update a route to ignore clips.

To unhook a route segment from a clip or hanger:

  1. Click Unhook From Clip (Routing Tools toolbar) or Routing, Routing Tools, Unhook From Clip.

  2. Specify route segments in the Unhook From Clip PropertyManager.

  3. Click .

You can also right-click the sketch segment under the clip and select Unhook from clip.

If you delete a clip from the route sub-assembly, then the next time you edit the route, the software informs you that a clip has been deleted and asks if you want to update the route. If you re-route, the route updates to a more direct path ignoring the original clip.

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Re-route to Ignore Clips
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21