Hide Table of Contents

Weld Bead Mate Surfaces

  1. Select the mate faces. Selections required depend on the Weld Bead Type you chose.

    • Click in the Contact Faces box, then select the faces of the components where you want the weld bead to be added.

    • Click in the Stop Faces box, then select the faces (usually four faces) where you want the weld bead to start and stop.

    • Click in the Top Faces box, then select the faces from which to measure the Top Surface Delta.

  2. Click Next.

    Related Topics

    Creating and Editing Weld Beads



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Weld Bead Mate Surfaces
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2010 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21