Hide Table of Contents

Configuring a Pre-2010 Pro/E Vault

The Enterprise PDM add-in is automatically activated in Pro/ENGINEER when you install and configure your pre-2010 Pro/E vault.

  1. Click Start > All Programs > SolidWorks Enterprise PDM > Administration
  2. In the SolidWorks Enterprise PDM Administration tool, log in to a vault, right-click the vault, and click Import.

  3. In the Open dialog box, navigate to install_dir\Default Data, select AddRenamer.caf, and click Open.
  4. Click OK.
  5. To import the Pro/ENGINEER cards, right-click Cards and click Open Card Editor.
  6. In the Card Editor, click File > Import.
  7. In the Open dialog box, navigate to install_dir\Default Cards, select one of the following cards, and click Open:
    • ProE Assembly_gb.crd
    • ProE Default_gb.crd
    • ProE Drawing_gb.crd
    • ProE Part_gb.crd
  8. Save the card to the vault.
  9. Repeat steps 6 through 8 to import the other Pro/ENGINEER cards.
  10. Repeat steps 1 through 9 for each pre-2010 Pro/ENGINEER vault.
Parent topic: Pro/ENGINEER Add-in


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Configuring a Pre-2010 Pro/E Vault
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS PDM 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21