Hide Table of Contents

Motion Loads from SolidWorks Motion

SolidWorks Simulation reads motion loads directly from SolidWorks Motion database. You can import loads at a single frame or multiple frames. When requesting multiple frames, SolidWorks Simulation creates a Design Study with the gravity loads along X, Y, and Z directions and the loads due to angular velocity and angular acceleration as the variables. You can then type required values for these variables. By default, the program creates constraints depending on the defined sensors and selects the Monitor Only option.

To import motion loads from SolidWorks Motion database:

  1. Click Simulation, Import Motion Loads.

  1. Select assembly component(s).

You cannot import to Simulation motion loads from components in a subassembly.

  1. Select Single Frame Study or Multiple Frame Study (Design Scenarios).

    • If you select Single Frame Study, specify the Frame No.

    • If you select Multiple Frame Study (Design Scenarios), specify the Start, End frame numbers and Step.

  2. Click OK.

The program creates a study with the name CM-ALT-Frame - <Number> in each selected component, where Number refers to the specified frame number for a Single Frame Study and start-end-step number for Multiple Frame Study. For multiple frames, the software creates a Non-Optimization Design Study . The software activates the Use Inertial Relief option in the properties of the study automatically.

  1. To evaluate results for a component, open the part document of the component.

  2. If you imported loads from a single motion frame, right-click the static study associated with the frame and select Run. If you imported loads from multiple motion frames, modify the static study if needed, set the values of variables and constraints and run the Design Study.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Motion Loads from SolidWorks Motion
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.