Hide Table of Contents

Graphing of Probed Result Plots

After using the probe tool to identify results at the desired locations, you can graph the results. You can use this functionality with any plot.

To generate a graph for the probed result plot:

  1. Activate the desired plot.

  2. Use the Probe Result tool to identify results at the desired locations.

The results appear under Results in the Probe Result PropertyManager.

  1. Under Report Options, click Plot or Response :

    • Plot . Generates a 2D graph of the results. Linear variation is assumed between listed values. The graph assumes equal distances between probed locations.

    • Response (available for transient studies only). Generates a 2D graph of the results versus solution steps.

The graph appears.

  1. Close the graph window and close the PropertyManager.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Graphing of Probed Result Plots
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.