Hide Table of Contents

Direct Mesh Referencing Method

After using the Mesh Prep Wizard, you can reference the mesh feature vertices to sketch directly on the mesh. Then you use the sketches to create surfaces and a solid model. Consumer product designers should use direct mesh referencing for complex shapes. You use direct mesh referencing because it is easier and more accurate than the Surface Wizard.

To use direct mesh referencing:

  1. Open a mesh file and prepare it using the Mesh Prep Wizard.

  2. Sketch spline points on the mesh that snap to mesh vertices.

In this example, you open a mesh of a complex hand control device.

Sketch

                    Mesh

  1. Complete the sketches by referencing the key design areas of the mesh. Here is an example of sketch splines that capture the design intent.

  1. Use the sketches to create surfaces.

  1. Use surfacing tools (such as Untrim, Trim, and Extend), to trim unwanted surfaces. Then knit the surfaces together and thicken them to create a solid model. Apply fillets as necessary to complete the solid model.

Related Topics

ScanTo3D Overview

Surface tools



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Direct Mesh Referencing
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.