Hide Table of Contents

1:1 Scale Output Warning

A warning appears if the following are enabled in DXF/DWG File Export Options:

  • Scale output 1:1

  • Warn me if enabled

Warning Options

Disable 1:1 Scale. Turn off the export scale option for this and subsequent export operations.

Don't warn me about this any more in this SolidWorks session. Turn off the warning message. You can turn it back on in the DXF/DWG File Export Options.

Exporting

The warning message appears as follows when exporting DXF/DWG files with Save As:

  • If you click Options in the Save As dialog box and select Scale output 1:1, the option is observed and no warning is issued.

  • In subsequent exports, if you:

  • Do not click Options, a warning is issued

  • Do click Options, no warning is issued (You do not have to select anything in the Export Options dialog box, only open it and click OK.)

  • If you select Don't warn me about this any more in this SolidWorks session in the warning dialog box, no warning appears for subsequent exports. To turn the warning back on, click Options in the Save As dialog box and select Warn me if enabled.

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   1:1 Scale Output Warning
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.