Hide Table of Contents

Surface Representation

Surface Representation

Exported IGES Entity Types

STANDARD

144, 142, 128, 126, 122, 120, 110, 102, 100

NURBS

144, 142, 128, 126, 110, 102, 100

ALIAS

144, 142, 128, 126, 122, 120, 110, 102, 100

ANSYS

144, 142, 128, 126, 110, 102, 100

COSMOS

144, 142, 128, 126, 110, 102, 100

MASTERCAM

144, 142, 128, 126, 110, 102, 100

SURFCAM

144, 142, 128, 126, 110, 102, 100

SMARTCAM

144, 142, 128, 126, 110, 102, 100

TEKSOFT

144, 142, 128, 126, 110, 102, 100

ALPHACAM

144, 142, 128, 126, 110, 102, 100

MULTICAD

144, 142, 128, 126, 110, 102, 100

NOTE: If the system you are exporting to is not listed, refer to the documentation for that system to see which entities are supported, and choose an appropriate setting.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Surface Representation
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.24