Hide Table of Contents

No Bends

You can roll back all bends from a sheet metal part in which bends have been inserted so that you can make additions, such as adding a wall. This is available only in sheet metal parts with Flatten-Bends1 and Process-Bends1 features.

To roll back all bends from a sheet metal part:

Click No Bends on the Sheet Metal toolbar to roll back the bends up to Sheet-Metal1.

The bend radius and bend allowance are rolled back. (The part is not flattened.)

art\NOBEND.gif

To restore all bends to the part:

Click No Bends again.

art\FLATTEN2.gif

 



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   No Bends
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21