Hide Table of Contents

Trim Side Bends

To remove extra material in neighboring bends, select Trim side bends. Extra material appears when one of the bends of a Miter Flange touches an existing bend. The cut that trims the neighboring bends is automatically sized, and cannot be edited. This example uses an Edge Flange feature:

This is the preview of an Edge Flange feature. The bend region of the blue preview touches the bend of the L-shaped base flange.

Result when Trim side bends is cleared.

Result when Trim side bends is selected.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Trim Side Bends
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46