Hide Table of Contents

Changing Mesh Settings

To change mesh settings:

  1. Click Change settings.
  2. Click Change mesh density.

    You see a dialog box that says changing mesh density deletes any results for the SimulationXpress study.

  3. Click OK to close the dialog.
  4. In the Mesh PropertyManager, adjust the mesh by dragging the slider.


    • Drag the slider to the right for a finer mesh (more accurate).
    • Drag the slider to the left for a coarser mesh (quicker).

  5. Click to remesh the model.
  6. Click Next.
  7. Click Run Simulation.
  8. Click Stop animation or Play animation .
  9. Review the animation and determine whether the loads and fixtures are applied properly.
    • Click Yes, continue if the animation is okay.
    • Otherwise, click No, return to Loads/Fixtures, modify the loads and fixtures as desired, and then rerun the study.
  10. When simulation is completed, a check mark appears next to Run and Results in the SimulationXpress wizard.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Changing Mesh Settings
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.24