Hide Table of Contents

Applying Pressure

You can apply multiple pressures to a single face or to multiple faces. The program applies pressure loads normal to each face.

To apply a pressure:

  1. Click Add a pressure.

    The Pressure PropertyManager appears.

  2. In the graphics area, click the desired faces.
  3. Select:
    • Normal to selected face to apply the pressure in the direction normal to each selected face.
    • Use reference geometry to apply the pressure in the direction of a selected reference plane.
      You need to select a reference plane in the FeatureManager design tree.
  4. Select the pressure units, then enter the pressure value.

    If necessary, select Reverse direction to reverse the direction of the pressure.

  5. Click .

    The pressure appears in the External Loads folder in the SimulationXpress study tree and a check mark appears next to Loads in the SimulationXpress wizard.

    To add or edit a pressure, click Add a pressure or Edit an existing force or pressure. To delete a pressure, right-click the pressure in the study tree and select Delete. To change the name of the pressure, click-pause-click the pressure name in the study tree and type the new name. You can also edit a pressure in the SimulationXpress study tree by right-clicking the pressure and selecting Edit Definition.

  6. Click Next.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Applying Pressure
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.