Hide Table of Contents

Recognizing Sweep Features

You can recognize boss and cut sweep features created with a profile and a path using interactive feature recognition.

You can recognize these types of sweep features:

Square-shaped profile

Semi-circular profile

Sweeps with internal loops

 

Boss sweep features
added to a base feature

Cut sweep features

 

You cannot recognize:

  • Sweep features with:

  • Orientation/twist Type other than Follow Path

  • Guide curves

  • Closed paths

  • 3D path curves

  • Profiles that have internal loops

  • Drafts



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Recognizing Sweep Features
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.53