> Electrical Attributes PropertyManager

Introduction

Administration

User Interface

SolidWorks Fundamentals

Design Studies in SolidWorks

Drawings and Detailing

Sustainability Products

Electrical Attributes PropertyManager

The Electrical Attributes PropertyManager appears when, while editing a cable route, you query the electrical attributes of the selected route segment. The PropertyManager displays the following properties:

Wire List

Lists the name of each wire or core that passes through the selected segment. The cut length of each wire appears in angle brackets after the wire name.

Properties

Lists the property names and values for the item currently selected in Wire List.

Additional Properties

Lists custom electrical properties for the item currently selected in Wire List.

If Wire List is empty, the electrical attributes of the selected route segment are undefined. See Edit Wires to associate cable/wire data with the route segment.

Search 'Electrical Attributes PropertyManager' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Electrical Attributes PropertyManager
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic
Just this topic
This topic and only immediate topics under it
This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.