Hide Table of Contents

Setting Multiple Jogs in Dimension Leaders

You can apply multiple jogs to existing dimension and callout leaders by clicking Multi-jog Leader from the Leaders tab of the Dimension PropertyManager. You can also add jogs after you place a dimension or callout by right-clicking and selecting Add Jog Point. Drag jog points to create the jog after inserting the jog point.

To include multiple jogs in leaders when creating radius, diameter, chamfer, or hole callout dimensions:

  1. Select Smart Dimension .
  2. In the graphics area, right-click and click Use Multi-jog Leader.
  3. Select the entity to dimension.
  4. Click to place leader jogs, and double-click to place the dimension.

    You can drag dimension jogs after setting them.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Setting Multiple Jogs in Dimension Leaders
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.