Hide Table of Contents

Hole Position PropertyManager

Use the hole series PropertyManagers to create a hole series. You can create a new hole or use existing holes for the hole series. To dimension the hole series, dimension the sketch points on the starting face.

Hole Position

  • Create new hole. Creates a hole series using new holes. Click the starting face to place sketch points.

  • Use existing hole(s). Creates a hole series using existing holes. All holes must be the same type and size. Select the holes.

    • Hole Wizard feature/pattern . Lists the selected holes.

    • Hole Position. Select Start, Middle, or End as the position for Hole type holes with Through All for the End Condition. Counterbore and countersink holes are automatically set as Start of the hole series. Blind drilled holes or tap holes are automatically set as End of the hole series.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Hole Position PropertyManager
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21