Hide Table of Contents

VRML Export Options

You can set the export options when you export SolidWorks part or assembly documents as VRML files.

To set the VRML export options:

  1. Click File, Save As.

  2. Select VRML (*.wrl) for Save as type, then click Options.

  3. Select from the options described below, then click OK.

  4. Click Save to export the document.

Output as

  • Version. Select the type supported by the target system. VRML 97 is also called VRML version 2.0.

  • Unit. Select the unit of length measurement.

Quality. To change the display resolution, click Tools, Options, Document Properties, Image Quality.

Save all components of the assembly in a single file (assemblies only).

Output coordinate system. Select a coordinate system to apply for export. If you select -- default --, no transformation matrix is applied.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   VRML Export Options
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2011 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.